Tuesday, November 11, 2014

Chevy Cobalt Replacing the front door speakers

One of the first things I do when I buy something used is to make a list of things to repair.  On the car it is something like this:
1. Prime
2. Paint
3. Undercoat
4. Door locks stick
5. Snow tires
6. Front Speakers
7. Do Spider Spikes fit?

So far 1, 2, and 5 are fixed.  When it comes to the front speakers Pioneer actually makes speakers that fit.  You can also buy an adapter that will allow you to use any 6.5 inch speaker if you want.  The wiring adapter is not needed.  Just tin the wires and they will fit tightly into the jack that was connected to the old speaker.

The new speakers come with clips that need to be installed first as seen in the picture below.

To install the speaker first remove or pry out the door cover near the speaker.  There are three screws behind plastic snap in covers that you will need to remove to take the inside door cover off.  Remove one screw and the old speaker comes out.  Connect the wires for the new speaker.  The wires can be taped in place with electrical tape.

Put one side of the new speaker in and then rotate it up and down to catch the two clips on the opposite side.  Tighten up the screws.  Use duct tape to fill the gaps above and below the new speaker to block road noise.

You are done!  It only takes ten minutes to do.  Turn on the radio and make sure that the new speakers work.

Now I can actually hear the turn signals, as the sound comes through the speakers.  Hopefully the warning that the headlights were left on will work too.


No comments: